Weather Stripping & Bottom Seal Replacement In Houston, TX

What We Replace/Install

Bottom seal (door sweep) on the bottom section

Side & top weather seal (molding trim around the frame)

Retainer (the metal/aluminum track that holds the bottom seal) if yours is bent or missing

Signs You Need A New Bottom Seal Or Weather Stripping

Daylight showing under/around the door

Water blowing in during storms

Bugs/lizards getting in

Leaves/dust coming in

Bottom rubber is cracked, stiff, or falling off

Our Installation Process

Inspect door edges + floor line (and check if the door is closing evenly)

Remove old seals and clean the contact surfaces

Install the correct seal type (not “one-size-fits-all”)

Test close/tightness and confirm smooth operation

What Affects The Total Price

Seal type needed: bottom seal only vs full perimeter (sides + top)

Door size: single vs double

Retainer condition: reuse vs replace (if bent/rusted)

Door alignment: if the door isn’t closing evenly, a seal alone won’t fix the gap

Frequently Asked Questions

How to get an accurate price for a new seals?

To get an accurate price for your weather-stripping or bottom seal, simply provide your garage door’s width and a photo of the current seal’s profile

Do you provide free on-site estimates?

Yes! we offer free on-site estimates for new installations and other services within our service areas—click here to check the areas we serve. If you are outside these zones, please call us at (XXX XXX XXXX) or click here to send us a message as we may still be able to help you.

My door leaves a gap on one side because the floor isn’t level, will replacing the bottom seal fix it?

Usually, yes—if the uneven spot is minor. We replace the bottom seal and adjust the door so it closes evenly, which often fixes small gaps. If the floor has a bigger dip/high spot, a standard seal may still leave a small gap in one area—then the right solution is typically adding/adjusting a garage-door threshold seal on the floor (or addressing the uneven concrete) so the seal has a flat surface to compress against.

What is the difference between a bottom seal and weather stripping?

The bottom seal sits on the floor; weather stripping (stop molding) goes around the sides and top of the door frame.

How do I stop water and pests from getting under my garage door?

The most effective solution is a combination of a high-quality U-shaped bottom seal and a garage door threshold. While the bottom rubber seal attaches to the door to close gaps, a threshold is glued directly to the concrete floor to create a physical barrier that redirects heavy rain away. For maximum protection against Houston’s humidity and rodents, we also recommend replacing worn-out weather stripping on the door frame to ensure an airtight finish on all sides.

How long does the replacement take?

Most replacements are done in one visit, within 1 hours

Take Action Now

Ready To Get a Quote?

(424) 461 6917

Get a Free Estimate

Schedule Service